8 Answers. If there was only one washer, it generally will go on the nut side as the nut has less surface area in contact with the thing being connected than the bolt side. Washers are used for multiple purposes when mechanical parts are assembled using bolts and nuts.Click to see full answer. Herein, which side of a washer goes down?The side with the sharper edges goes towards the surface to be clamped. The rounded side goes towards the nut or bolt. If a split lock washer is also used it goes between the nut/bolt and the flat washer. This holds for stamped washers. which washer goes on first? Ideally the lock washer goes into the threaded fastener first followed by the flat washer. This way the lock washer adds tension to the fastener assembly. It creates pressure on the bolt or nut (depending on where it is used) to prevent the assembly from loosening when it is exposed to vibration. Beside this, does washer or dryer go on top? No, you can only stack a dryer on top. Washing machines are too heavy, especially when full of water and wet clothes. They also vibrate more during operation as their spin speeds are higher, increasing the risk of accidents if stacked.Where do you put a washing machine?Always place a washer under the part that is twisting when tightening up. If access dictates the head of the bolt is turned when tightening, place the washer under this. If you are doing up the nut, place the washer under the nut. If both can turn, the washers should be under under both.
ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6dpp6rXayutLTEq2Sgp12ku27AzqlkqKpdl7y1wM6mZGtn